Bluetooth: Host: SSP: Correct BR bonding type #78832
Merged
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Currently, the bonding type of Authentication
_Requirements parameter is always
Dedicated Bonding
if the device is pairing initiator.But if the bonding is performed during
connection setup or channel establishment as
a precursor to accessing a service, the
bonding type should be
General bonding
.Add a flag BT_CONN_BR_GENERAL_BONDING.
Set the flag if the bonding is performed in
the L2CAP_BR/RFCOMM channel establishment.
Set bonding type depends on the flag when
receiving IO cap request.