Skip to content

wdomski/SX1278-example

Repository files navigation

SX1278-example

Example for STM32 HAL driver for LoRa SX1278 module

This is an example project for SX1278 LoRa wireless communication module. It includes the diver. The driver itself can be found in SX1278 repository. For more information on the driver including what LoRa modules are supported please refer to the README file in SX1278 repository.

First version of the example was prepared with SW4STM32 IDE for STM32F103C8T6 development board and can be easily ported to any other device. Also STM32CubeMX configuration file is included. The current state of the project was prepared for Nucleo-L476RG development board.

Installation

First download this project. Preferably with git clone. Remeber to download submodules for this repo.

git clone [email protected]:wdomski/SX1278-example.git
cd SX1278-example
git submodule update --init --recursive

How to use it

Prerequisite

You need two boards, preferably identical, and two SX1278 modules. One of the boards will work as master and the other one will work as slave. Master is sending data to slave. Also switching operation mode is possible by pressing user button available at the board.

Debugger -- ST-Link V2 with SWV capabilities. Please remember to upgrade the firmware in ST-Link

Connecting module

The module has to be connected with the MCU board with following pins:

MCU pin SX1278 pin Description
PA4 NSS SPI chip--select
PB10 SCK SPI SCK
PC2 SO SPI MISO
PC3 SI SPI MOSI
PB0 DIO0 LoRa interrupt indicator pin (for receiver mode)
PB1 RST LoRa reset
------- ---------- -------------------------------------------------
VDD VCC +3V3
VSS GND GND

Compilation

You have to compile it using STM32CubeIDE.

Run

After flashing the image you should mind the PC13 port. To this a blue push button is connected. It is configured as input and depending on its state the board boots as a master or as a slave. For master mode the PC13 has to be pulled high (button not pressed). For slave mode the PC13 has to be pulled low (button pressed).

All the communication is going through redirected printf to SWV and USART2. This is duplicated due to more robustness. You can use either. To read the communicates you have to have ST-Link Utility installed. There you can chose Printf via SWO viewer. When using serial interface any serial terminal is suitable. The configuration is standard 115200 8N1 (115200 bps, 8 bits for frame, no parity and a single STOP bit).

The master board is constantly sending messages while the slave is constantly reading them. To change the operation simply push the blue button and hold it for a moment.

Final remarks

You can visit my blog to read more about the SX1278 modules or my other projects.

About

Example for STM32 HAL driver for LoRa SX1278 module

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages