This is the Motion Engine for the Arduino/nanoMoCo Platform.
Version: 1.0.7
You must install the following libraries to compile the MotionEngine:
For more information on installing libraries in Arduino, see Arduino Libraries Guide.
Key tips for uploading to the nanoMoCo:
- Ensure you select 'Arduino Uno' as the Board Type
- You have 8 seconds after powering on the nanoMoCo to begin uploading firmware
- You may only upload firmware over the RS485 interface
This bundle includes a bootloader for the nanoMoCo, or any ATMega328p device, to upload firmware over RS485. Play with at will.
More information can be found at http://www.dynamicperception.com/
(c) 2008-2013 C.A. Church / Dynamic Perception LLC
The Motion Engine firmware is distributed under a GPLv3 License. See LICENSE.txt for licensing information.