Skip to content

Prototype single channel power sensing module for sentry

Notifications You must be signed in to change notification settings

hkustenterprize/powerAmplifier

Repository files navigation

powerAmplifier

Prototype single channel power sensing module for sentry

Hardware

Sensing power with STM32F373 SDADC and precision frontend.
Low side shunt current measurement topology.
Schematics available in Alex Wong's brain, open singlePowerAmp.ioc with STM32CubeMx to see STM32 connections.
Be careful with the input and output direction, also the power polarity. Try not to mess with the XT60 leads attatched to the screw terminals.
Hardware draws power from the main power input, but does not measure the current used by itself.

Software

Current software writen uses STM32Cube HAL, generated by STM32CubeMx.
Voltage and current measured at 50kHz and down sampled to 1kHz with software oversampling to improve SNR.
Firmware runs bare-metal (no RTOS).

About

Prototype single channel power sensing module for sentry

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published