ESP-BOX v0.1.1 is the first update for ESP32-S3-BOX development board.

Update and Flash Firmware

To flash firmware under Windows system, please to the Firmware update for Windows

To flash firmware under Linux system, please to the Firmware update for Linux

To flash firmware under macOS system, please to the Firmware update for macOS

Troubleshooting

Program upload failure
- Hardware connection is not correct: run idf.py -p PORT monitor, and reboot your board to see if there are any output logs.
- Try to put ESP32-S3 into download mode. To do this, keep GPIO0 low while toggling reset. On many development boards, the “Boot” button is connected to GPIO0, and you can press “Reset” button while holding “Boot”.
LCD does not display properly or flickers
- Make sure that the MUTE button is not pressed, and the yellow indicator light on the top of the development board is not lit.
- If there is still no response, reset the device or reconnect the USB-C cable.
No response after scanning the QR code
- Try to manually connect to the AP displayed on the screen and enter the URL in the browser.