- Install MyStudio https://github.com/elephantrobotics/MyStudio/releases
- Download Leapmotion
- install this two file
- Burn AtomMain（MyStudio->Basic->AtomMain）into ATOM
Burn Transponder（MyStudio->Tools->Transponder）into BASIC
- check the usb port
- enter the port
- After LeapmotionController successfully starts, Mycobot will adjusts to initial position automatically
- Use gestures to control MyCobot to move
- If you start LeapMotionController and enter port number, it stops on the following page and you cannot control MyCobot through LeapMotion
Check that the driver has been installed successfully:
If the driver has been successfully installed but the version is too low, it is recommended to change to the driver provided by us - When controlling MyCobot with Leapmotion, Mycobot will return to initial position when the hand is out of range of Leapmotion’s detection
- MyCobot moves in response to gesture and cannot hover in one position