-
Notifications
You must be signed in to change notification settings - Fork 22
System architecture
Andrew Zonenberg edited this page Aug 26, 2018
·
2 revisions
- Artix-7 FGG484 FPGA
- Barrel jack for +12V power (current requirements TBD)
- DDR3 SODIMM slot for 4GB of DDR3 800+
- RJ45 for 1000baseT to PC
- SFP+ cage for 10gbase-R to PC
- 128x64 OLED display for showing IP address etc during setup
- 4x Samtec Q-strip for I/O boards (pitch TBD)
- Dimensions TBD
- Samtec Q-strip to system board
- Samtec Q-strip to probe board
- Screw holes/standoffs to mate to carrier board
- Samtec Q-strip to I/O board
- Screw holes/standoffs to mate to probe board (and possibly host board too)
- 0.1" headers to micro-clip test leads
- 2x9 header... 8 signal grounds, 8 signals, 1 power ground, 1 VCCO track input
- Samtec Q-strip to probe board
- Screw holes/standoffs to mate to probe board (and possibly host board too)
- TBD connector to coaxial 1K ohm resistive probes