Two fixes to the leveling section of the startup guide #292
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
The guide recommends `bed_tilt` which is the wrong functionality in klipper. Both printers use `z_tilt` along with `screws_tilt_adjust`.
|
thanks for that |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
I was reconfiguring my Legacy and noticed the guide references https://www.klipper3d.org/Config_Reference.html#bed_tilt instead of https://www.klipper3d.org/Config_Reference.html#z_tilt. As far as I can tell from both the V1 and the Legacy firmware configuration, the correct one is
z_tilt.