Add u-boot-qcom recipe. This fetch from Linaro repo and build the
u-boot-qcs6490-rb3gen2.mbn ready to be flashed into rb3gen2 board
usind fastboot:
fastboot flash uefi_a ./u-boot-qcs6490-rb3gen2.mbn
Some logs:
U-Boot 2024.10-rc4-00620-ga61af132fb90 (Sep 09 2024 - 10:00:06 +0000)
Model: Qualcomm Technologies, Inc. Robotics RB3gen2
DRAM: 6 GiB (effective 5.9 GiB)
serial_msm_geni serial@994000: pinctrl_select_state_full: uclass_get_device_by_phandle_id: err=-19
serial_msm_geni serial@994000: pinctrl_select_state_full: uclass_get_device_by_phandle_id: err=-19
Core: 57 devices, 28 uclasses, devicetree: board
Loading Environment from nowhere... OK
In: serial,button-kbd
Out: serial,vidconsole
Err: serial,vidconsole
qcom-ufshcd ufs@1d84000: Qcom UFS HC version: 4.3.0
qcom-ufshcd ufs@1d84000: [RX, TX]: gear=[3, 3], lane[2, 2], pwr[FAST MODE, FAST MODE], rate = 2
QCOM-FMP: Failed to find boot partition
Net: No ethernet found.
scanning bus for devices...
Device 0: (0:0) Vendor: SAMSUNG Prod.: KM2L9001CM-B518 Rev: 0700
Type: Hard Disk
Capacity: 118871.9 MB = 116.0 GB (30431231 x 4096)
Device 1: (0:1) Vendor: SAMSUNG Prod.: KM2L9001CM-B518 Rev: 0700
Type: Hard Disk
Capacity: 7.9 MB = 0.0 GB (2047 x 4096)
Device 2: (0:2) Vendor: SAMSUNG Prod.: KM2L9001CM-B518 Rev: 0700
Type: Hard Disk
Capacity: 7.9 MB = 0.0 GB (2047 x 4096)
Device 3: (0:3) Vendor: SAMSUNG Prod.: KM2L9001CM-B518 Rev: 0700
Type: Hard Disk
Capacity: 31.9 MB = 0.0 GB (8191 x 4096)
Device 4: (0:4) Vendor: SAMSUNG Prod.: KM2L9001CM-B518 Rev: 0700
Type: Hard Disk
Capacity: 3071.9 MB = 2.9 GB (786431 x 4096)
Device 5: (0:5) Vendor: SAMSUNG Prod.: KM2L9001CM-B518 Rev: 0700
Type: Hard Disk
Capacity: 31.9 MB = 0.0 GB (8191 x 4096)
starting USB...
Bus usb@a600000: Register 2000340 NbrPorts 2
Starting the controller
USB XHCI 1.10
scanning bus usb@a600000 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot: 0
=> <INTERRUPT>
Signed-off-by: Tommaso Merciai <[email protected]>