Corresponds with PrusaSlicer 2.6.0 release.
Changes since v2.5:
- Updated to PrusaSlicer 2.6.0 settings.
- Top & bottom infill pattern for all but the rougher profiles are now ‘monotonic lines’.
- ‘Infill only where needed’ has been dropped (because it no longer exists). In the Start G-code summary, it has been replaced by top & bottom infill pattern.
Reminder: if you are upgrading from 2.3 or older, here is an important bit of the 2.4 release notes:
- Configuration has been separated from the make_fcp_x3g.pl script. You should no longer edit the script, only the config text file. See the README for updated instructions.
- A quick checklist for migrating your config lines from the old script to the new text file:
- Convert single quotes to double quotes.
- Omit commas in [ARRAY] type items. Put each array element between double quotes and separate elements with a space.
- No trailing semicolons.