Support for NOUS A1T

[vreesie18]

Description

Is there any change of getting support for the NOUS A1T in the near future or am I missing something and is there already support for this device ?

Kind regards,
Andre

Solution

No response

Alternatives

No response

Additional context

No response

[mcspr]

/CF1_PIN.* 5/ in our hardware .h shows various devices with almost similar config based on a single relay and HLW8012 / HJL01 / BL0937. Seems to be this one?

HYKKER_SMART_HOME_POWER_PLUG

espurna/code/espurna/config/hardware.h

Lines 4868 to 4910 in 1e765d7

	// -----------------------------------------------------------------------------
	// Hykker Power Plug (Smart Home Series) available in Jerónimo Martins Polska (Biedronka)
	// https://www.hykker.com/akcesoria/gniazdo-wi-fi-z-licznikiem-energii/
	// Reflashing from original Tuya firmware
	// to thirdparty firmware like espurna by:
	// https://github.com/ct-Open-Source/tuya-convert
	// -----------------------------------------------------------------------------
	#elif defined(HYKKER_SMART_HOME_POWER_PLUG)
	// Info
	#define MANUFACTURER "HYKKER"
	#define DEVICE "SMART_HOME_POWER_PLUG"
	// Buttons
	#define BUTTON1_PIN 0
	#define BUTTON1_CONFIG BUTTON_PUSHBUTTON | BUTTON_DEFAULT_HIGH
	#define BUTTON1_RELAY 1
	// Relays
	#define RELAY1_PIN 14
	#define RELAY1_TYPE RELAY_TYPE_NORMAL
	// LED
	// Red
	#define LED1_PIN 13
	#define LED1_MODE LED_MODE_WIFI
	#define LED1_PIN_INVERSE 1
	// Blue connected to relay
	// HLW8012
	#ifndef HLW8012_SUPPORT
	#define HLW8012_SUPPORT 1
	#endif
	#define HLW8012_SEL_PIN 12
	#define HLW8012_CF1_PIN 5
	#define HLW8012_CF_PIN 4
	#define HLW8012_SEL_CURRENT LOW
	#define HLW8012_CURRENT_RATIO 25740
	#define HLW8012_VOLTAGE_RATIO 282060
	#define HLW8012_POWER_RATIO 3414290
	#define HLW8012_INTERRUPT_ON FALLING

ref. https://templates.blakadder.com/nous_A1T.html
ref. https://nous.technology/product/a1t.html

[vreesie18]

Looks like it, same pin layout :-) I will give it a try!

[Homer-Sim]

Hello,

I am using for the NUOS A1T this firmware:
espurna-1.15.0-dev.git909949b5+github230112-avatto-power-plug-wifi

it is working but today I recognized that the Voltage value is quite high:

230 is the expected value ...

I tried to go under sensors and added the 230V to voltage#0 and hit calculating/apply but it did not change something

Any ideas?

[Homer-Sim]

I am really searching for a solution because I do not like the Tasmota Firmware; I am so used to ESPurna on all my devices.

I tried for sure also this one:
espurna-1.15.0-dev.gitb409dc27+github230330-hykker-smart-home-power-plug
But I receive higher voltage values (~266V)

Please.

[mcspr]

I tried to go under sensors and added the 230V to voltage#0 and hit calculating/apply but it did not change something
Any ideas?

Click 'Save' so settings are preserved?