-
|
In the GUI, if you look at QMK Settings -> Tap-Hold tab, there is a checkbox for Ignore Mod Tap Interrupt. What is that mapped to in the QMK firmware code? I want to be able to set this flag by default when I compile my firmware. I tried setting this in config.h, but got an error when i tried to compile. error was: After removing that define from config.h and re-flashing firmware, I opened the GUI and that checkbox is not checked. The behavior I am expecting is also incorrect. When I check the checkbox and click Save button, I get the desired behavior. I'm trying to figure out what code modification I need to make to have this setting enabled by default. Thank you! |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
There isn't a configuration setting to change the default values for tap-hold behavior (although perhaps the default should follow qmk's), but you can patch it in https://github.com/vial-kb/vial-qmk/blob/f06a05a5d5e2e4e92d4ae28628cebaba2b9c32f0/quantum/qmk_settings.c#L184 by changing it to |
Beta Was this translation helpful? Give feedback.
-
|
thank you @xyzz ! |
Beta Was this translation helpful? Give feedback.
There isn't a configuration setting to change the default values for tap-hold behavior (although perhaps the default should follow qmk's), but you can patch it in https://github.com/vial-kb/vial-qmk/blob/f06a05a5d5e2e4e92d4ae28628cebaba2b9c32f0/quantum/qmk_settings.c#L184 by changing it to
QS.tapping = 2;