Skip to content

Latest commit

 

History

History
48 lines (38 loc) · 2.2 KB

LDAP.md

File metadata and controls

48 lines (38 loc) · 2.2 KB
Raw

LDAP

Overview

Helix Server has long supported LDAP for user authentication, and that does not change when used in concert with the authentication extension. The server can support users that authenticate with either a database password (default Perforce authentication), an LDAP-based password (as defined with p4 ldap), as well as SSO authentication by means of the auth-check-sso trigger (which the authentication extension implements).

Perforce Configuration

Permitting a combination of authentication mechanisms is a matter of setting the Perforce configuration appropriately, and defining which users are authenticated by which method.

Start by defining an LDAP configuration in Perforce using the p4 ldap command as described in this knowledge base guide.

Once a basic LDAP configuration is in place, define several settings that will allow a combination of authentication paths, as shown below:

$ p4 configure set auth.default.method=ldap
$ p4 configure set auth.ldap.order.1=<name-of-your-ldap-config>
$ p4 configure set auth.sso.allow.passwd=1
$ p4 configure set auth.sso.nonldap=1

The above commands set LDAP as the default authentication mechanism, but allow for non-LDAP users (those whose AuthMethod is set to perforce), and additionally instructs the SSO mechanism to allow "password" authenticated users (those users that are authenticated by the server without delegation to LDAP or SSO). This is just an example, and by no means the only possible configuration.

Once the configuration is in place, those users that will be using LDAP authentication must have their AuthMethod set to ldap. For any user whose AuthMethod is set to ldap the authentication extension will defer their authentication to the server, which will use LDAP, if given the configuration shown above.

Users that will authenticate with a database password should be named in either the non-sso-users extension configuration, or belong to a group named in non-sso-groups, and have their AuthMethod set to perforce. This setting, in combination with auth.sso.allow.passwd=1, instructs the server to use the database password for non-SSO and non-LDAP users.