Can not get Crazyflie to hover in a stable state #131
Replies: 4 comments 3 replies
-
I am facing the same issue. |
Beta Was this translation helpful? Give feedback.
-
Hi! We need to have more information about your issue:
|
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
If you are flying it with a controller + flowdeck, you are either flying it in attitude mode (not with position feedback) or position hold (which uses position feedback). There is an button on the controller that you can use. But in general, flying with a flow deck is just very much easier to let it do autonomously. Either use the commander panel of the flight tab here (make sure to disconnect your controller before opening the cfclient) or just try out the motion commander demo of the cflib. |
Beta Was this translation helpful? Give feedback.
-
Hi,
I just bought a Crazyflie drone and completed setting it up. However, I can not get it to hover in a stable state. The Flight data on the Crazyflie client on the Windows shows that there are some ghost values on the pitch and roll and hence I think the drone is drifting. Am I doing anything wrong, or is this normal?
Beta Was this translation helpful? Give feedback.
All reactions