Replies: 2 comments
-
The probe offset can be adjusted in the Probe menu. Did you already adjust it there? |
Beta Was this translation helpful? Give feedback.
0 replies
-
Check: https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hello, I am using the "Ender3V2-SKRME3V3-BLTUBL-MPC-20230312.bin" firmware on my Ender 3 V2 printer with a BTT SKR MINI E3 V3 motherboard and a BLTouch. However, I am using the VORON design and my BLTouch is slightly to the left compared to the previous setup, so the center of my print bed is not being detected. Can anyone help me with how to adjust it as shown in the picture?
https://ibb.co/L9jxLsp
https://ibb.co/LZH1m2f
Beta Was this translation helpful? Give feedback.
All reactions