MPC Autotune not working for me #599
Unanswered
krak3n1013
asked this question in
Q&A
Replies: 3 comments 7 replies
-
Did you save the MPC parameters after the test? |
Beta Was this translation helpful? Give feedback.
0 replies
-
I'm pretty sure I saved once tune was done. Going to download and try installing T13-MPC firmware again. |
Beta Was this translation helpful? Give feedback.
6 replies
-
Hey @krak3n1013, I have the same exact issue did you figured it out? I wanted to take a moment to express my sincerest gratitude for the remarkable work you have put into developing the firmware @mriscoc |
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Trying to figure out this MPC Autotune on my Ender 3 v2 w/ Sprite Pro, using firmware "Ender3V2-422-BLTUBL-T13-MPC".
When I ran the autotune test, the test worked great, heated nozzle to 209c and the test did it's thing. Once test was done I tried heating nozzle to my operating print temp, the heater shot past the my set print temp and kept on climbing until I turned my printer off. I then turned my printer back on and cooled it down some and then tried heating up my nozzle again, set nozzle temp to my print temp and again the heater shot past my set temp and kept on climbing. Also it doesn't matter what temp I set, I tried at 10c and at 100c, at both those temps the nozzle heater just climbed in temp until I stopped it. What can I do to fix this?
Beta Was this translation helpful? Give feedback.
All reactions