Replies: 1 comment 1 reply
-
|
Check notes about CRTouch: https://github.com/mriscoc/Ender3V2S1/wiki/3D-BLTouch#notes-about-crtouch |
Beta Was this translation helpful? Give feedback.
1 reply
-
|
Much appreciated. Thank you sir! I will make the recommended corrections. But do we know why? Why would it consistently fail at the same number of probes? And why does the BL not do this? |
Beta Was this translation helpful? Give feedback.
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Using Ender3V2-427-BLT configuration on an ender 3; whenever I set it to 9x9 it fails every time on point 67 and restarts the leveling. Gets to point 67 again and repeats. It never finishes. I have the exact same firmware with Ender3V2-422-BLT config on an ender3v2 and the 9x9 is working perfectly.
On the 4.2.7 board I can only set a max of 8x8 or it will fail at point 67.
One thing that should not matter - the 4.2.2 is using a BLTouch while the 4.2.7 is using a CRTouch.
Please advise.
Beta Was this translation helpful? Give feedback.
All reactions