Sprite addition #221
Unanswered
Comicrocket
asked this question in
Q&A
Replies: 1 comment
-
I swapped to a sprite on my E3v2 and used the suggested step change from the sprite reference book thing then installed the bltouch version of the firmware for my board. I had to do some calibration to get everything squared away since the sprite is a bit bulkier in areas. I haven't had any issues as far as I can tell. Granted I'm still relatively new to the sport |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Could you have it so that we can install a creality sprite extruder on a V2?
Beta Was this translation helpful? Give feedback.
All reactions