-
|
I am coming from jyers, I was able to do a 15x15 mesh, which worked out to about 145 points. I am seeing this only goes to 9x9, is there a way to adjust it higher? |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 2 replies
-
|
No, this firmware limits the mesh size to a 9x9 matrix, that is enough for beds about 450 x 450 mm^2. You can change that limit editing the firmware but some text formatting problems could arise. |
Beta Was this translation helpful? Give feedback.
-
|
may I ask why jyers was able to do it without issue? |
Beta Was this translation helpful? Give feedback.
-
|
Just a matter of preference, I prefer that practical limit, more points are more a placebo effect for small beds and that limit allows to save up to 6 different mesh slots. |
Beta Was this translation helpful? Give feedback.
-
|
there is no need for 15x15 mesh which does not equal 145 points, |
Beta Was this translation helpful? Give feedback.
No, this firmware limits the mesh size to a 9x9 matrix, that is enough for beds about 450 x 450 mm^2. You can change that limit editing the firmware but some text formatting problems could arise.