You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm not sure if this is a strictly firmware-related issue. Instead, I guess this is a setup/fine-tuning of the mriscoc firmware. I uploaded it to my Ender 3 v2 a couple of days ago, as well as the CR Touch probe. Since then, low adherence started to happen as shown in the pictures below. What could be the cause?
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
I'm not sure if this is a strictly firmware-related issue. Instead, I guess this is a setup/fine-tuning of the mriscoc firmware. I uploaded it to my Ender 3 v2 a couple of days ago, as well as the CR Touch probe. Since then, low adherence started to happen as shown in the pictures below. What could be the cause?
I did everything that's described in https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides
The source of the calibration file shown in the pictures is https://www.thingiverse.com/thing:4642274
I'm using Cura 5.0.0
Then I printed a 20mm XYZ calibration cube (https://www.thingiverse.com/thing:1278865)
Any idea? TIA
Beta Was this translation helpful? Give feedback.
All reactions