Sometimes my printer stows the probe while building a mesh. #1017
Unanswered
Heros-Tempus
asked this question in
Q&A
Replies: 1 comment 1 reply
-
CRTouch? How is the HS mode? |
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I've been using the August pre-release firmware on my ender 3 s1. I have absolutely no idea why this happens, but occasionally while constructing a mesh the probe tip will stow before it comes down on the test point. Since the probe tip is stowed, the head winds up moving down further than expected, then the printer panics and it is killed before the head crashes into the bed. Usually I am able to just turn it off then on then start building the mesh again without issue, but it would be nice to know what is causing this.
Beta Was this translation helpful? Give feedback.
All reactions