You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I will use the limit switches with inductive sensors. I have put a optocoupler board as a level shifter between sensors and input pins.
But when sensors triggers, the voltage drops to 2.3 volt. I am using grbl 5x. Is there a software solution or I have to remove Pull Up Resistors on the board?
If I must desolder the Pull Up Resistors of the limit switches can you give me the names of the resistors.
My board is "MKS GEN L 2.1".
The text was updated successfully, but these errors were encountered:
I will use the limit switches with inductive sensors. I have put a optocoupler board as a level shifter between sensors and input pins.
But when sensors triggers, the voltage drops to 2.3 volt. I am using grbl 5x. Is there a software solution or I have to remove Pull Up Resistors on the board?
If I must desolder the Pull Up Resistors of the limit switches can you give me the names of the resistors.
My board is "MKS GEN L 2.1".
The text was updated successfully, but these errors were encountered: