Including TIMELAPSE_TAKE_FRAME into CURA slice fails to print (successfully)

[DoomerDGR8]

Hi!

I have the setup done correctly as I'm manually sending the TIMELAPSE_TAKE_FRAME command at random intervals and can generate a small video.

I'm facing an issue when I use the Extensions to set up a TIMELAPSE_TAKE_FRAME at layer change. Any sliced g-code that has this command, once loaded into the printer, the N4Pro will start the printing process and the extruder will move to home and immediately report print completed successfully—no error whatsoever.

If I slice without the Extension call, everything is ok.