Skip to content

Latest commit

 

History

History
43 lines (29 loc) · 2.05 KB

README.md

File metadata and controls

43 lines (29 loc) · 2.05 KB

USB 2.0 Full-Speed Device HWIP Technical Specification

usbdev:

Overview

This document specifies the USB device hardware IP functionality. This IP block implements a Full-Speed device according to the USB 2.0 specification. It is attached to the chip interconnect bus as a peripheral module and conforms to the Comportable guideline for peripheral functionality.

Features

The IP block implements the following features:

  • USB 2.0 Full-Speed (12 Mbps) Device interface
  • 2 kB interface buffer
  • Up to 12 endpoints (including required Endpoint 0), configurable using a compile-time Verilog parameter
  • Support for USB packet sizes up to 64 bytes
  • Support SETUP, IN and OUT transactions
  • Support for Bulk, Control, Interrupt and Isochronous endpoints and transactions
  • Streaming possible through software
  • Interrupts for packet reception and transmission
  • Flippable D+/D- pins, configurable via software, useful if it helps routing the PCB or if D+/D- are mapped to SBU1/SBU2 pins of USB-C

Isochronous transfers larger than 64 bytes are currently not supported. This feature might be added in a later version of this IP.

Description

The USB device module is a simple software-driven generic USB device interface for Full-Speed USB 2.0 operation. The IP includes the physical layer interface, the low level USB protocol and a packet buffer interface to the software. The physical layer interface features multiple transmit and receive paths to allow interfacing with a variety of USB PHYs or regular 3.3V IO pads for FPGA prototyping.

Compatibility

The USB device programming interface is not based on any existing interface.