You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I am running DPPP 5.1 on a recently observed data set where two stations, namely DE602HBA and DE605HBA, are fully flagged. If I try to run ddecal calibration within DPPP it creates solutions although stations are flagged.
So clearly DE602HBA (59) and DE605HBA (62) are fully flagged.
But nevertheless if I run a calibration step "valid solutions" are created.
I use the following parsets for calibration:
Dear all,
I am running
DPPP 5.1
on a recently observed data set where two stations, namelyDE602HBA
andDE605HBA
, are fully flagged. If I try to runddecal
calibration withinDPPP
it creates solutions although stations are flagged.I checked it with the count statement:
So clearly
DE602HBA
(59) andDE605HBA
(62) are fully flagged.But nevertheless if I run a calibration step "valid solutions" are created.
I use the following parsets for calibration:
and
I plotted the
h5parm
phase results and I see unflagged solutions forDE602HBA
andDE605HBA
:Is there an option to enable I miss here or is this the intended behaviour?
Alex
The text was updated successfully, but these errors were encountered: