Replies: 2 comments 4 replies
-
Which mode? From the $341 setting. |
Beta Was this translation helpful? Give feedback.
2 replies
-
What is your grblHAL version ($I output). |
Beta Was this translation helpful? Give feedback.
2 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
After manual tool change a cycle start from the UI, causes the program to resume. But if I use the cycle start switch after tool change I get error 40.
Normally i would go for the cycle start switch to avoid greasy stuff on the mouse/track pad. Is this by design or have i missed something
I am on the STM32F4xx driver and custom board.... checked on IO sender manual tool change mode....similar behaviour
Beta Was this translation helpful? Give feedback.
All reactions