layout submission

[joamatab]

There is a Layout Submission due Feb 13, 2024, 11:00 PM PST for the edx course

in case someone is interested in getting their design fabricated and tested

it's a great opportunity to write a paper about the end to end flow

Send PR if you want to get your device fabricated

@MRBaozi
@SkandanC
@nikosavola
@das-dias

• course link
• slides from course
• demo slides

Make sure it's DRC clean

[joamatab]

next course will start next week

https://www.edx.org/course/silicon-photonics-design-fabrication-and-data-ana

[das-dias]

Thank you. I think I am finally ready for enrolling in this edition of the course, as I already have been reading and exploring how I can use gdsfactory to accomplish most of the simulations the course requires. Best regards, Diogo Andre Joaquin Matres ***@***.***> escreveu no dia quinta, 13/04/2023 à(s) 17:48:

…

next course will start next week https://www.edx.org/course/silicon-photonics-design-fabrication-and-data-ana — Reply to this email directly, view it on GitHub <#176 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AQ45GB3JS6EJPFJSIZLPUGTXBAU7XANCNFSM6AAAAAAUR6GDFI> . You are receiving this because you were mentioned.Message ID: ***@***.***>