Copyright 2010 Freetronics Pty Ltd
Freetronics site: <www.freetronics.com>
Freetronics email: [email protected]
A general-purpose 433MHz receiver shield for the Arduino Duemilanove microcontroller and other boards based on the same header format, such as the Seeeduino and the Arduino Pro.
Includes significant prototyping area using the spare shield area.
Note that this design uses 0603 surface-mount parts and is intended for machine assembly, but could still be assembled by hand with a fine-tip soldering iron, a steady hand, and some magnification.
Features:
- Reset button wired through to Arduino reset pin.
- Two general-purpose surface-mount LEDs wired to GND via current- limiting resistors (drive HIGH to illuminate).
- Pads for 2 surface-mount 100nF smoothing capacitors.
- Parts overlay on both the top and the bottom so you can see what you are connecting without turning the board over.
More information is available on our product page at:
http://www.freetronics.com/products/433mhz-receiver-shield
The "docs" folder within this repository includes a handy copy of the schematic in PDF format and image(s) of the pcb.
The design is saved as an EAGLE project. EAGLE PCB design software is available from www.cadsoftusa.com free for non-commercial use. To use this project download it and place the directory containing these files into the "eagle" directory on your computer. Then open EAGLE and navigate to Projects -> eagle -> Rx433Shield.
The specific terms of distribution of this project are governed by the license referenced below.
Licensed under the TAPR Open Hardware License (www.tapr.org/OHL). The "license" folder within this repository also contains a copy of this license in plain text format.