Datalink not working #2617
-
|
Hi! Thanks! |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 10 replies
-
|
Have you turned on both D/L? |
Beta Was this translation helpful? Give feedback.
-
|
*in case you want to have the information on the center MFD :) |
Beta Was this translation helpful? Give feedback.
-
|
Hey! thanks for taking the time to follow up.
SA is empty there, I think I enabled it correctly This is for another mission:
SA page shows the DL contacts, no issues there I tried repairing the installation and still the same. |
Beta Was this translation helpful? Give feedback.
-
|
Hey, just wanted to say that there have been a number of folks who have had issues with datalink in the Hornet in the past. I believe that in all those cases, it turned out to be PEBSAT errors (afaik), and they were all able to get it working eventually. Ultimately, not a Liberation issue. That said, if you do figure out the issue with your procedure, please do post an update here about where the problem lay because I'm sure you're not going to be the last one with this problem. Best of luck getting it figured out! 🙂 |
Beta Was this translation helpful? Give feedback.
-
|
hey, thanks! I assume that PEBSAT error is another way to say Layer 8 error, right? hehe, yes, it's probably something like that, I'm continuing that campaign and I'll see if I find what's causing that issue, most likely something I'm just doing wrong or specific to my setup. D/L for other planes, like the F-14 are working just fine on the same campaign, so it shouldn't be something about the mission or how the awacs is set up. |
Beta Was this translation helpful? Give feedback.
-
|
Problem Exists Between Stick And Throttle, so yeah. Layer 8. 😄 Does datalink work on the Hornet outside of Liberation campaigns? |
Beta Was this translation helpful? Give feedback.
-
|
Don´t know if its important, but I get ALGN in the D/L UFC |
Beta Was this translation helpful? Give feedback.
-
|
hey, thanks! yes, I do get that ALGN when I'm on the carrier, still nothing pop ups on the SA page. It must be something specific to this campaign or my setup |
Beta Was this translation helpful? Give feedback.
hey, thanks! I assume that PEBSAT error is another way to say Layer 8 error, right? hehe, yes, it's probably something like that, I'm continuing that campaign and I'll see if I find what's causing that issue, most likely something I'm just doing wrong or specific to my setup. D/L for other planes, like the F-14 are working just fine on the same campaign, so it shouldn't be something about the mission or how the awacs is set up.