You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I am using Raspberry Pi 4B model to setup adhoc mode using TP-Link T3U Plus WIFI USB Adapter.
All building and installation process was smooth. I am able to see IBSS mode in the iw list command output. I was able to configure adhoc mode with default wlan0 in Raspberry Pi, however, same configure by replacing wlan0 with wlan1 is not working.
I am using Raspberry Pi 4B model to setup adhoc mode using TP-Link T3U Plus WIFI USB Adapter.
All building and installation process was smooth. I am able to see IBSS mode in the iw list command output. I was able to configure adhoc mode with default wlan0 in Raspberry Pi, however, same configure by replacing wlan0 with wlan1 is not working.
$ iwconfig
wlan1 IEEE 802.11bg ESSID:"adhoc" Nickname:"WIFI@REALTEK"
Mode:Ad-Hoc Frequency:2.412 GHz Cell: 02:11:87:F2:38:7B
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=92/100 Signal level=90/100 Noise level=0/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Does this driver support 'adhoc' mode on 2.4 and 5G band?
The text was updated successfully, but these errors were encountered: