This firmware is written in C. Version 0.2.
Derived from Grbl v0.9 by Jesús Arroyo (Mundo Reader S.L.)
Grbl's lead developer is Simen Svale Skogsrud. Sonney Jeon (Chamnit) improved some parts of grbl.
- Angular stepper motor movement
- Interrupt based movement with real angular acceleration
- Laser modules control
- Analog sensor read
- Configuration interface with $ commands
The default baudrate is 115200.
- G1 - Angular movement
- G50 - Reset all positions to zero
- M0 - Program pause
- M2 - Program end and reset
- M17 - Enable/Power stepper motor
- M18 - Disable stepper motor
- M50 - Read LDR
- M70 - Laser off
- M71 - Laser on
Open horus-fw.ino, select your board and upload.
sudo apt-get install gcc-avr avr-libc
makeThe binary horus-fw.hex can be flashed with Horus GUI.