Can't communicate with my Dshot

[SirRites]

After downloading the sketch and connecting the equipment, I see this in the terminal, how can this be solved?

[stylesuxx]

Not enough information whatsoever. Which firmware is running in the ESC? Which Arduino is bein used? Is the ESC confirmed to be working? How does your wiring look like - post pictures please?

[SirRites]

I use: Arduino Uno
Firmware on the regulator: BLheli_32
ESC really works, I tested it on other equipment
I connect common GND and signal cable from ESC to Arduino in 8 pin
I also connect 13 pins of Arduino to +5v
Third party sketches allowed me to run my engine on the same hardware, but I needed telemetry, which is missing in third party sketches
I use ESC: HOBBYWING XROTOR MICRO 40A 3-6S BLHELI_32 DSHOT1200 WITH LED INDICATOR
When connecting the ESC to Arduino, I do not hear the initialization sound of the ESC, which is produced when there is a control signal as in other sketches

[stylesuxx]

You would need to scope out what's happening on the signal line. Obviously the ESC is not recognizing the DShot Signal.

I might have some time on the weekend to have a look at this with a BLheli32 ESC.

This is all really only ment to be a debugging help during Bluejay development, so I don't advice to use this in any productive environment...

[SirRites]

Hello, were you able to see the solution to my problem over the weekend?

Вам нужно будет выяснить, что происходит на сигнальной линии. Очевидно, что ESC не распознает сигнал DShot.

Возможно, на выходных у меня будет время взглянуть на это с помощью регулятора скорости BLheli32.

На самом деле все это предназначено только для помощи при отладке во время разработки Bluejay, поэтому я не советую использовать это в какой-либо продуктивной среде...