Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Working Processor swap to STM32 on YST-DXT-J20 V4 Motherboard : no motor control yet #121

Open
123JRM opened this issue Sep 28, 2021 · 0 comments

Comments

@123JRM
Copy link

123JRM commented Sep 28, 2021

Hello all,

I found lack of documentation for the Avery AT32F403 aggravating so I decided to buy an STM32F103 and swap it out on my YST board. I now use the PlatformIO system on Visual Studio and it works pretty good. I am using a fork this firmware located here https://github.com/bipropellant/bipropellant-hoverboard-firmware . I have a 3.3 volt serial connected to C9,B2 and that works too. I have ASCII control of the board. I also have the STlink connected for debug and that works as well. using the software ASCII console I am unable to rotate the motors and I think it relates to different drive circuitry on the YST boards. I have been intently comparing the various differences in the makefile looking for the area that addresses the motor control of the AT32 system that i will need to substitute in so that I have that in my ST32 firmware. I hope this makes sense. I am slowly coming up to speed with the code but so far I have been unable to find what I need. I see references to a current limiting system being controlled with a gpio pin on the new boards but i can not find that code either.

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

No branches or pull requests

1 participant