The SV number selected for control does not respond on the Fuji thermostat. #1683
Replies: 5 comments 5 replies
-
Beta Was this translation helpful? Give feedback.
-
|
I don't know the background of this development project, try to use. |
Beta Was this translation helpful? Give feedback.
-
|
I think I catched this one. A typo was introduced in 2.8.4 causing this function to fail. I commited a fix in cf09ec4 and hope this will resolve the issue. A new continuous build should soon be available. |
Beta Was this translation helpful? Give feedback.
-
|
This has been fixed. Thank You！ |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
|
You need to have the Ramp/Soak OFF and the PID ON. |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
Switchover between RUN and standby |
Beta Was this translation helpful? Give feedback.
-
|
Well, that whole Fuji PID support was written over 10 years ago, before Artisan supported the general MODBUS protocol. Maybe all this should just be removed. |
Beta Was this translation helpful? Give feedback.
-
|
Fuji Temperature Control General MODBUS protocol for more flexible configuration control, Test it out of curiosity，Wasting your precious time. |
Beta Was this translation helpful? Give feedback.
-
In past versions can be set to switch normally.
Beta Was this translation helpful? Give feedback.
All reactions