New Laser Master 2 20w will not engrave #1132
Replies: 16 comments
-
Does the laser turn on? |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
Thank you so much for answering me. I didn't quite understand your last comment... Where do I need to put the formula you wrote on your comment: G1 F1 M3 S* (1000 - this is the number that is in $30). Thanks! |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
OK I tried that - changed to enable laser mode and added the code but still nothing has changed.... |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
you are an angel, but still - I tried everything you said and nothing is happening ): |
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
It worked!!!!! can you explain maybe why? so I will understand what I did wrong...? |
Beta Was this translation helpful? Give feedback.
-
Well, I think it needs an effective power range and speed. You need to check where it started burning (it is a 5.5W laser according to the online description, just like mine, so maybe around ~3000 @ 600mm/min). This will be really time consuming, because you have to try a lot of settings. Luckily, LaserGRBL has a material DB ( As for the mirror writing, you might need to change the direction of one axis. (use |
Beta Was this translation helpful? Give feedback.
-
Thanks again for all your explanation, I really appreciate your help!!!!! It was super useful (: |
Beta Was this translation helpful? Give feedback.
-
Glad I could help ^^ |
Beta Was this translation helpful? Give feedback.
-
Alex, do you know what can be the reason for these (unwanted) lines being engraved and how I might be able to avoid them? Thanks |
Beta Was this translation helpful? Give feedback.
-
Have you tried increasing the White clip slider where you prepare the image. |
Beta Was this translation helpful? Give feedback.
-
I will give it a try, thanks! |
Beta Was this translation helpful? Give feedback.
-
I cannot get my new Ortur Laser Master 2 to engrave using Laser GRBL. When I hit the "laser" custom button it fires a burn mark into my work piece. When I attempt to engrave, it seems to run correctly but it doesn't seem to have any power from the laser so it doesn't burn anything at all.
What am I missing? Any help is appreciated.
Beta Was this translation helpful? Give feedback.
All reactions