Replies: 5 comments
-
For your laser to move to Z0 after it finished a job, you need to set the footer section in LaserGRBL. For your second question, well... you need to 'manually' go to Z30, as I'm afraid I don't know an easy way to set position. The hard way would be using offsets, but that also requires setting it to 0 first. |
Beta Was this translation helpful? Give feedback.
-
@ gmmanonymus111. |
Beta Was this translation helpful? Give feedback.
-
@StuartB4 By google translate it seemed he does not want to move, as the laser is already there. He wants to tell it to GRBL as well, without moving. |
Beta Was this translation helpful? Give feedback.
-
That's what I understood as well, just thought that would be one way of having Z at 30. But then if he uses homing it would probably go back to 0 anyway as soon as he homes it. I can't think of any other way of doing it. |
Beta Was this translation helpful? Give feedback.
-
Se non esiste un modo su grbl di impostare una posizione fittizzia senza movimento potrei fare l'homing di Z in alto e poi scendere di quanto mi serve per portare l'asse a 30 dal basso verso l'alto. Tutto questo mi serve in quanto ho l'asse z disabilitata da firmware, non eseguo l'homing z, ma ho i limiti soft abilitati. La mia posizione di Z è fissa a 30 (manualmente), mio fuoco, ma se voglio fare passaggi multipli e scendere di 1 si attivano i limiti soft in quanto la Z per grbl è Z0. Quindi volevo dire a GRBL che già è a Z30 e posso scendere e salire di quanto voglio anche in funzione dello spessore del pezzo da lavorare. |
Beta Was this translation helpful? Give feedback.
-
Salve, nell'aggiornamento 3.1.3 è stato introdotto "aggiungi esportazione con intestazione / piè di pagina e passaggio multiplo" e ho pensato questo: supponiamo che eseguo un taglio e quindi ho la necessità di fare 2 passaggi affondando il secondo di 1mm. Perfetto usando
G91
G0 Z-1
G90
ma se voglio fare un altro taglio di un oggetto diverso, file diverso, mi ritrovo la Z fuori fuoco laser in quanto si trova a Z-1. Questo perchè finendo il lavoro non esegue il movimento inverso riportando la Z alla sua posizione iniziale.
Come potrei sistemare per fare in modo che dopo l'ultimo passaggio mi porta la Z in posizione iniziale?
Inoltre come potrei dire a GRBL di avere già la Z a +30mm al primo avvio? Non parlo di portare la Z a +30 ma di indicare che già si trova a+30mm. Grazie
Beta Was this translation helpful? Give feedback.
All reactions