New Graphical editing window for waveforms in RedHawk 2.0

[tandersoft]

The graphical editor for waveforms is much improved in RedHawk 2.0. The connection lines are bolder. Rather than routing them around other objects with square corners the connection lines go straight between ports. This is unusual as most graphical editors DO route, but the previous (1.10 and before) did a poor job dealing with connections from right to left (ie. out port to an in port on a component to the left. Over all this is better even though a little ugly, but it would be much nicer if in ports could be optionally placed on the right side and out ports optionally placed on the left rather than having no control of the side a port is placed on. This could be done by either allowing ports to be dragged around to place them, or a boolean selection on the waveform wizard port add for right/left. This would make diagrams for communications waveforms which usually have payload paths both left to right and right to left, look much nicer.

[tandersoft]

Print also sides not seem to work in RedHawk 2.0 for waveform graphical window. I just get a blank page.