G21 ;(metric values)
G90 ;(absolute positioning)
M82 ;(set extruder to absolute mode)
M107 ;(start with the fan off)
G28 ;(Home the printer)
G92 E0 ;(Reset the extruder to 0)
G0 Z5 E5 F500 ;(Move up and prime the nozzle)
G0 X-1 Z0 ;(Move outside the printable area)
G1 Y60 E8 F500 ;(Draw a priming/wiping line to the rear)
G1 X-1 ;(Move a little closer to the print area)
G1 Y10 E16 F500 ;(draw more priming/wiping)
G1 E15 F250 ;(Small retract)
G92 E0 ;(Zero the extruder)
G0 Z120 Y120 X110 ;(Move to the top back)
G92 E0 ;(reset the extruder position)
;G1 E-30 ;(retract a bunch)
M104 S0 ;(turn off hotend/extruder heater)
M140 S0 ;(turn off bed heater)
G92 E10 ;(Set extruder to 10)
G1 E7 F200 ;(retract 3mm)
G4 S15 ;(Delay 15 seconds)
M107 ;(Turn off part fan)
M84 ;(Turn off stepper motors.)
X | Y | Z | E | |
---|---|---|---|---|
V1 | 93.00 | 93.00 | 1097.50 | 97.00 |
V2 | 46.50 | 46.50 | 548.75 | 48.50 |
V2 (post 06-2017) | 93.00 | 93.00 | 1097.50 | 97.00 |
- Run the command
M503
on the printer - Look for the line that looks like
with whatever your current values are.
M92 X<xx.xx> Y<yy.yy> Z<zz.zz> E<ee.ee>
- For each of the axes
- Zero a caliper on the nozzle carriage's current position.
- Command the printer to move by a certain amount (make note of how much). Note: the further it moves, the more accurate you can be.
- Measure the ammount the printer actually moved.
- Determine the new eStep value with the formula
(expected_distance / actual_distance) * current_estep_setting = new_estep_setting
- Send the command for
- x-axis:
M92 X<calcualted new value>
- y-axis:
M92 Y<calcualted new value>
- z-axis:
M92 Z<calcualted new value>
- Extruder:
M92 E<calcualted new value>
- x-axis:
- Save the setting with the command
M500
- Repeat this process to confirm that the settings were well-dialed-in
- Filament Guide, M6 Bowden Adapter
- 40mm Hotend Cooling
- 40mm Combined Cooling Shroud Replacement -- Medicore at part cooling
- 40mm Hotend Cooling with 5015 Part Cooling -- Compatible with v2
- 40mm Hotend Cooling with 5015 Part Cooling -- Compatible with v1
- Bed
- Side Panels
- Endstop Relocation