udpgen

Overview

This tool was written to help stress test OpenNMS' UDP protocol handling by generating large volumes of traffic.

It currently supports generating:

• SNMP Traps
• Syslog Messages
• Netflow 5 flows
• Netflow 9 flows

The tool does not currently give fine grained control over the payload generation.

Building

Requirements

• cmake
• net-snmp-devel

Compiling

mkdir build
cd build
cmake ..
make

Usage

udpgen [-d] [-i] [-h host] [-p port] [-r rate] [-t threads] [-z packets] [-x type]

• -x: Type of payload: snmp, syslog, netflow5, netflow9 (default: syslog)
• -d: Daemonize (default: false)
• -i: Disable interactivity (default: false)
• -h: Target host / IP address (default: 127.0.0.1)
• -p: Target port (default: depends on mode)
• -r: Rate - number of packets per second to generate (default: 10000) Set the rate to 0 in order to disable rate limiting
• -s: Send X number of packets and then stop
• -S: Senx packets for X number of seconds and then stop
• -t: Number of threads used to generate packets (default: 1)
• -z: Number of packets per iteration (default: 1) Increase this when sending packets at a high rate

Examples

Generate Syslog Message

Generate 100000 Syslog messages per second over 10 threads, targeted at 172.23.1.1:514.

./udpgen -r 100000 -t 10 -h 172.23.1.1 -p 514

Pin udpgen to the first core, and generate as many Syslog messages as possible using a single thread.

taskset -c 0 ./udpgen -r 0

Generate SNMP Traps

Generate 200000 SNMPv2 traps per second over 8 threads, targeted at 127.0.0.1:1162.

./udpgen -x snmp -r 200000 -t 8

Generate Netflow 9 flows

Generate as many Netflow 9 flows as possible using a single thread pinned to the first core:

taskset -c 0 ./udpgen -x netflow9 -r 0