diff --git a/parts/chapters/subsections/8.3/ROCKTAB.fodt b/parts/chapters/subsections/8.3/ROCKTAB.fodt index ab6b7c92..148650da 100644 --- a/parts/chapters/subsections/8.3/ROCKTAB.fodt +++ b/parts/chapters/subsections/8.3/ROCKTAB.fodt @@ -2500,7 +2500,7 @@ Updated with AFR/TSA Rev-D comments and new keywords. - + @@ -2540,7 +2540,7 @@ Updated with AFR/TSA Rev-D comments and new keywords. - + @@ -2735,7 +2735,7 @@ Updated with AFR/TSA Rev-D comments and new keywords. - + @@ -4253,8 +4253,7 @@ Updated with AFR/TSA Rev-D comments and new keywords. Description - The ROCKTAB keyword defines the rock compaction attributes to be applied for when the rock compaction option has been invoked by the ROCKCOMP keyword in the RUNSPEC section. ROCKTAB defines pore volume and transmissibility multipliers versus pressure that are used in the compaction calculations. If the RKTRMDIR has been activated in the PROPS section, then the transmissibility multiplier is directional dependent and two additional columns are used to define the y and z direction transmissibility multipliers. - This keyword is not supported by OPM Flow but has no effect on the results so it will be ignored. + The ROCKTAB keyword defines the rock compaction attributes to be applied when the rock compaction option has been invoked by the ROCKCOMP keyword in the RUNSPEC section. ROCKTAB defines pore volume and transmissibility multipliers versus pressure that are used in the compaction calculations. If the RKTRMDIR has been activated in the PROPS section, then the transmissibility multiplier is directional dependent and two additional columns are used to define the y and z direction transmissibility multipliers. @@ -4302,7 +4301,7 @@ Updated with AFR/TSA Rev-D comments and new keywords. If the ROCKOPT1 variable has been set to PRESSURE on the ROCKOPTS keyword in the PROPS section, then PRESS should be a columnar vector of real monotonically increasing down the column values, that define the reference pressure for which the other parameters correspond to. - If ROCKOPT1 has been set to STRESS, then PRESS should be a columnar vector of real monotonically decreasing down the column values. + If ROCKOPT1 has been set to STRESS, then PRESS should be a columnar vector of real monotonically decreasing down the column values.