You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Is the problem here that the default wait.complete() waits 5 seconds, then times-out with no error, whereas wait.complete(600) wait for 10 minutes, and so the whole test times out with a fail?
Branche 2.9 RIP Installation
I experimented with warning Python WaitCommandComplete timed out
https://forum.linuxcnc.org/38-general-linuxcnc-questions/52141-warning-python-waitcommandcomplete-timed-out
I found out that /tests/abort/g64/test.ini is not working well.
If you run it normally, the result is OK.
(Error - Python WaitCommandComplete timed out - this is my warnings)
If you change this line
linuxcnc/tests/abort/g64/test-ui.py
Line 96 in bc56a86
to
c.wait_complete(600)
and let the test run in its entirety. The result is not OK.
This Issue points to two problems:
The text was updated successfully, but these errors were encountered: