-
|
Hi, new to the forum. Im trying to run a Spider 1.1 with 5160 drivers and get the following error when using octopi/klipper on a Pi4: Quite a few pins in this config seem to be allocated to spi2, any advise on how to solve this? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
The solution was... RTFM. I neglected to set the spi bus to spi4 (spi_bus: spi4) in the config for the drivers, once the pin allocation collision was resolved believe it or not this problem went away. Leaving this up for any others who might also get lost in their spi config settings... |
Beta Was this translation helpful? Give feedback.
The solution was... RTFM.
I neglected to set the spi bus to spi4 (spi_bus: spi4) in the config for the drivers, once the pin allocation collision was resolved believe it or not this problem went away. Leaving this up for any others who might also get lost in their spi config settings...