You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
No matter if I use the buddy site or download the bootloader/firmware I am unable to flash to any 2.10.x version of EdgeTX, the most recent version I have success with is EdgeTX "Providence" v2.9.4. I was able to flash 2.9.4 using the .bin file from the SD card or using the buddy site. If there's anything newer that I try, it appears to flash. After the flash, I unplug the cable, but when I go to try to power back on the radio, all I get is flashing white lights at the top.
Expected Behavior
When I run the firmware push from the buddy site, after the flash is complete, I unplug the USB-C cable and start the radio. It powers up and shows me the Edge TX logo and works and operates normally.
Steps To Reproduce
To reproduce the problem, I could just try to flash any 2.10 version and it will fail.
Version
2.10.4
Transmitter
Jumper T16
Operating System (OS)
Windows
OS Version
11
Anything else?
No response
The text was updated successfully, but these errors were encountered:
The Jumper T16 I have access to was running 2.10.3, and I was just able to DFU flash it with 2.10.5 using EdgeTX Buddy, with a successful boot afterwards, so not sure what is going on there.
Has this handset been modified an any way?
If you want to double check, this is the (zipped) firmware I just flashed : t16-v2.10.5.zip
Is there an existing issue for this problem?
What part of EdgeTX is the focus of this bug?
Transmitter firmware
Current Behavior
No matter if I use the buddy site or download the bootloader/firmware I am unable to flash to any 2.10.x version of EdgeTX, the most recent version I have success with is EdgeTX "Providence" v2.9.4. I was able to flash 2.9.4 using the .bin file from the SD card or using the buddy site. If there's anything newer that I try, it appears to flash. After the flash, I unplug the cable, but when I go to try to power back on the radio, all I get is flashing white lights at the top.
Expected Behavior
When I run the firmware push from the buddy site, after the flash is complete, I unplug the USB-C cable and start the radio. It powers up and shows me the Edge TX logo and works and operates normally.
Steps To Reproduce
To reproduce the problem, I could just try to flash any 2.10 version and it will fail.
Version
2.10.4
Transmitter
Jumper T16
Operating System (OS)
Windows
OS Version
11
Anything else?
No response
The text was updated successfully, but these errors were encountered: