Source code of prtouchV2 and z_compensate

[henrivdr]

@Taylor111593 @CrealityTech please release the source of prtouchV2 and z_compensate.
We need to help troubleshoot what's going on with ZZ_AUTO_ZOFFSET.

Have a look on the forums. Users are reporting that Auto Zoffset is even worse than before, after upgrading to v27.

Your probably have to release the code for the toolhead MCU as well.
So we can look at the ADC conversion that is done on the load cell.

I have found a variance of 0.07mm over 8 consecutive probes.
That is maybe acceptable, but then there are random peaks of 0.2mm which can cause the nozzle to crash into the bed.

Also see my pull request which will make it easier for the English community to read the code and contribute.

Thanks

[AmberHelios]

Please release the source, @CrealityTech what you have made is great but it needs some work lot of good people can help if you just let us

[morten-arntun]

I have this same issue.
The auto bed leveling system is not consistent,

[ezequiel-gg]

same issue here

[vitaslash]

I'm already tired of struggling with this printer. it is simply impossible to use it. I don't want to get involved with creality products anymore. Thanks for the $300 thrown in the trash